Scandoil  

Power Supplies for the Efficient, Flexible Use of Distributed Controllers


Published Nov 6, 2017
[an error occurred while processing this directive]

Edit page New page Hide edit links

Siemens Simatic ET 200SP PS
Siemens is bringing onto the market the Simatic ET 200SP PS, a single-phase power supply for the Simatic ET 200SP distributed I/O system (photo: Siemens)

Siemens is bringing onto the market the Simatic ET 200SP PS, a single-phase power supply for the Simatic ET 200SP distributed I/O system. The 24-volt power supplies from the Sitop product family supply rated currents of 5 and 10 amperes, and their design, construction and functionality are optimally matched to the distributed controller. An on/off switch for the 24 volts, and plug-in terminals for three load circuits simplify the commissioning and maintenance of the system. The power supply has a current monitor that outputs the momentary output current and enables, for example, optimisation of the energy management. A mounting depth of a mere 75 mm allows the power supply to be used on flat distribution boards.

The output voltage is adjustable up to 28 V in order to compensate for voltage drops on long lines. The extremely flat design and low heat development of the power supplies allow space-saving mounting in distribution boards. They also have an extended ambient temperature range from -30° to +70° C and an efficiency of up to 90%, which keeps heat development down. On account of the automatic switchover of the input voltage (85-132/170-264 V AC) and comprehensive certifications, the power supplies can be used all over the world. Large power reserves of 1.5 times the rated current for “extra power” for 5 s/min ensure trouble-free switching of loads with a high inrush current and reliable operation.

The on/off switch for the 24 volts allows the floating exchange of the distributed I/O modules. Plug-in terminals allow three separate load circuits to be disconnected and so simplify commissioning and maintenance of the system. The current monitor outputs the present output current as a voltage value, and can be wired to an analogue input. In this case, 1 V corresponds to the rated current of the power supply, that is 5 A or 10 A. The measurement allows users not only to diagnose the load current at any time and detect faults through an increased current requirement, but also to optimise the energy management.

Tags: Siemens




Advertisment:

Comments on this page are closed.

+ Larger Font | + Smaller Font
Top Stories

 

 

 

 


 


RSS

RSS
Newsletter
Newsletter
Mobile News
Mobile news

Computer
Our news on
your website


Facebook
Facebook
Twitter
Twitter

Contact
Contact
Tips
Do you have any
tips to us
Stats

 

sitemap xml