Scandoil  

Successful Completion of Chain Tensioning and Cutting on New GoM FPSO


Published Jun 9, 2016
Turritella FPSO - Acteon
Turritella FPSO (photo: Acteon)

InterMoor, an Acteon company, has successfully completed the final tensioning and chain cutting operations on the FPSO Turritella for the Shell Stones project, located in the Walker Ridge protraction area in the Gulf of Mexico (GoM).

The FPSO Turritella will connect to subsea infrastructure located beneath approximately 9500 feet (2896 m) of water, breaking the existing water depth record for an oil and gas production facility. This ultra-deep water project marks the first FPSO for Shell in the GoM, and the second FPSO in the GoM.

Having arrived in January 2016, the Turritella is a dis-connectable turret moored FPSO with nine mooring lines consisting of chain and polyester, arrayed in three bundles of three. The mooring lines were attached to a dis-connectable Buoyant Turret Mooring (BTM) buoy in field, awaiting the FPSO’s arrival. Each mooring leg has an in-line mooring connector (ILMC) tensioning system, located approximately 900 feet below the surface, which was pre-tensioned after connection to the BTM. Once the Turritella arrived, and the BTM was recovered by the FPSO. InterMoor’s work scope consisted of chain final tension adjustments through the ILMC system, subsequent cut and removal of excess chain, and riser pull-in rope stretching and transfer to the FPSO.

InterMoor used the Seacor Keith Cowan anchor-handling vessel (AHV) to perform the first phase of the operations and later moved to a larger construction vessel already on charter and on standby.

Tom Fulton, global president, InterMoor, says, “InterMoor supported this FPSO’s mooring needs by utilising a cost-effective and Jones Act compliant anchor handling vessel, whereas competitors would typically resort to a large construction vessel. We were able to successfully provide full project management and engineering, including design, procedures, procurement, dock support, offshore equipment and personnel for all phases. Our team also designed installation aids and fabricated them in our Morgan City facility, in Louisiana.”

Acteon sister companies worked alongside InterMoor on the project, with UTEC providing the positioning survey for the AHV, and Mirage custom-designing and fabricating the diamond wire cutting saw and clamping system.

Tags: Acteon Group, InterMoor, Shell




Advertisment:

Add a Comment to this Article

Please be civil. Job and promotion will not be added into the comment page.

(Use Markdown for formatting.)

This question helps prevent spam:

+ Larger Font | + Smaller Font
Top Stories

 

 

 

 


 


RSS

RSS
Newsletter
Newsletter
Mobile News
Mobile news

Computer
Our news on
your website


Facebook
Facebook
Twitter
Twitter

Contact
Contact
Tips
Do you have any
tips to us
Stats

 

sitemap xml